Usually if you drag and drop a tile onto a wall in Innoplus, the tile will completely cover the wall. However, you may only want the tile to reach a certain height, start at a certain height or cover a stripe of the wall without reaching to the floor or the ceiling.
There are two different ways to define that height.
Defining tiling height using rows
-
In the assistant box, located to the right of your screen, under the Settings tab, select Basic tiling.
- In the Area section, select Rows and set the number of rows you required in the field alongside.
Defining tiling height using height indication
-
In the assistant box, located to the right of your screen, under the Settings tab, select Basic tiling.
- In the Area section, select in height from and define the lower limit where you wish the tiling to start in the field alongside, and then define the upper limit in the up to field.
Related articles
How to use the tile area function
How to use models to create tile areas